Filter
Top Products
2-20
Canceling watchman
1. Press the [MENU] key.
2. Press the omnipad at 6 o’clock to
select Mode & Function and press the
[ENT] key.
3. Press the omnipad at 6 o’clock to
select Watchman.
4. Press the omnipad at 3 o’clock/9
o’clock to select OFF.
5. Press the [ENT] key followed by the
[MENU] key.
2.27 Erasing the Heading
Marker
The heading marker continuously appears
on the display and shows your vessel’s
heading. When this mark obscures a target
echo, you can temporarily erase it by
pressing and holding down the [HM OFF]
key. Release the key to redisplay the
marker.
2.28 Deselecting Ranges
This radar has 16 ranges, some which you
may not require. You can deselect up to
fourteen ranges as follows.
1. Press the [MENU] key.
2. Press the omnipad at 6 o’clock to
select Mode & Function and press the
[ENT] key.
3. Select Range and press the [ENT] key.
Active ranges appear in reverse video.
4. Press the omnipad at 3 o’clock/9
o’clock to select range to disable (or
enable) and press the [ENT] key.
Current selection is underlined.
5. Press the [ENT] key.
6. Repeat steps 4 and 5 to disable (or
enable) other ranges.
7. When finished, press the [MENU] key.
2.29 Displaying Navigation
Data During Stand-by
Various navigation data can be displayed
during stand-by. A barometer is built in this
radar; atmospheric pressure appears, in
graph form, on the navigation data display
during stand-by. If your navigation aid can
output data in NMEA 0183 data format,
your vessel’s position in latitude and
longitude, the range and bearing to
waypoint, speed, course, date, time and
cross track error may be input to this radar,
and be seen in the bottom text area during
stand-by. Further, with video sounder input,
depth may be displayed, both digitally and
in graph form.
The barometer and depth displays are intended
as reference. Any data displayed by them should
be used with extreme caution.
CAUTION
Procedure
1. Press the [MENU] key.
2. Press the omnipad at 6 o’clock to
select the Nav Data and press the
[ENT] key.
3. Press the omnipad at 6 o’clock to
select STBY Display.
4. Press the omnipad at 3 o’clock/9
o’clock to select NAV and press the
[ENT] key.
5. Press the [MENU] key.