Filter
Top Products
10. CUSTOMIZING YOUR UNIT
10-9
FORMAT
Selects NMEA0183 version 1.5 or 2.0. If you
are unsure of the version number, try both
equipment and choose the one which
outputs data correctly.
LAT/LON FORMAT (GGA only)
Selects the minutes of latitude and longitude
positions in hundredths, thousandths or ten
thousandths.
SELECT SNTNC. soft key
This key enables/disables input/output of
data sentences.
SETUP NMEA/DGPS PORT 2 menu
description
This menu should be set according to the
specifications of the equipment connected to
connectors PORT 2 (DGPS) at the rear of
the display unit. The menu can be displayed
by pressing the [MENU] key followed by the
CONFIGURATION and SETUP NMEA
PORT 2 soft keys. For detailed information,
see the Installation Manual.
FORMAT
Selects data format of connected equipment;
NMEA0183 version 1.5, version 2.0,
RTCM104 (EXTRN), RTCM104 (INTRN) or
RTCM104 (OUTPUT). RTCM104 (INTRN) or
RTCM104 (OUTPUT) is for GP-1850WD
only.
LAT/LON FORMAT (GGA only)
This setting can be performed when
NMEA0183 Ver.1.5 or 2.0 is selected as the
FORMAT. It displays the minutes of latitude
and longitude positions in hundredths,
thousandths or ten thousandths.
UPLOAD/DOWNLOAD DATA menu
This menu allows you to upload waypoint
and route data to a PC or download the
same data from a PC, via the DGPS
connector at the back of display unit. The
menu can be displayed by pressing the
[MENU] key followed by the
CONFIGURATION and
UPLOAD/DOWNLOAD DATA soft keys. For
detailed information, see the Installation
Manual
DWNLOAD
UPLOAD
DGPS 3D
DOWNLOAD WPT/RTE TO PC
UPLOAD WPT/RTE FROM PC
RETURN
SAVE DATA TO MEMORY CARD
LOAD DATA FROM MEMORY CARD
Upload/download menu
ANT XDR
TEMP/SPD
DGPS
NMEA
+ GND
1 3
2
-
12 - 24
VDC
Connect PC to DGPS.
Display unit, rear view
Set communication software on the PC as
follows:
Baud Rate: 4800 bps
Character Length: 8 bit
Stop bit: 1 bit
Parity: None
X Control: XON/XOFF