Filter
Top Products
7
2.2 COM Port Setup, Network Setup
The FA-30 is set up from the PC or external display. The procedure below shows how
to set up the COM/POWER and NETWORK ports from a PC.
NOTICE: Only one FA-30 may be connected to the network.
Start up
1. Start up the PC and enter IP address and subnet mask.
1) Right-click My Network and Properties.
2) Right-click Local Area Network and Properties.
3) Select Internet Protocol and Properties.
4) Enter IP address 172.31.24.xxx (xxx=any three digits from 001 to 254, except
002).
5) Enter subnet mask 255.255.0.0.
2. Open Internet Explorer and do the following:
1) Click Tools on the menu bar.
2) Click Internet Options.
3) The General tab is selected. Click Settings at Temporary Internet Files.
4) Click the radio button “Every visit to the page” at “Check for newer versions of
stored page”.
5) Click the OK button.
6) Click the OK button again.
3. Enter URL as http://172.31.24.2 and press the Enter key.
4. Click Port Setup to show the Port Setup menu.