Filter
Top Products
Never place any part of the body underneath
equipment or between moveable parts even
when the engine has been turned off. Hydraulic
system leak down, hydraulic system failures,
mechanical failures, or movement of control
levers can cause equipment to drop or rotate
unexpectedly and cause severe injury or
death.
• Service work does not require going under-
neath.
• Read Manual for service instructions or have
service performed by a qualified dealer.
• Stop tractor and implement immediately upon
striking an obstruction. Turn off engine, remove
key, inspect, and repair any damage before
resuming operation.
• Always wear relatively tight and belted cloth-
ing to avoid entanglement in moving parts.
Wear sturdy, rough-soled work shoes and pro-
tective equipment for eyes, hair, hands, hear-
ing, and head.
Owner/Operator
Pre-Operation Checklist
(Owner’s/Operator’s Responsibility)
____ Review and follow all safety rules and
safety decal instructions on page 2 through
page 6.
____ Check that equipment is properly and
securely attached to tractor.
____ Check that all safety decals are installed
and in good condition. Replace if damaged.
____ Check that all hardware is properly
installed and secured.
____ Do not allow riders.
____ Make sure tractor ROPS or ROPS CAB
and seat belt are in good condition. Keep seat
belt securely fastened during operation.
Operation 15
Safety is a primary concern in the design and
manufacture of our products. Unfortunately, our
efforts to provide safe equipment can be wiped
out by an operator’s single careless act.
In addition to the design and configuration of
equipment, hazard control and accident pre-
vention are dependent upon the awareness,
concern, judgement, and proper training of per-
sonnel involved in the operation, transport,
maintenance and storage of equipment.
It has been said “The best safety device is an
informed, careful operator. ”We ask you to be
that kind of operator".
The operator is responsible for the safe opera-
tion of this equipment. The operator must be
properly trained. Operators should be familiar
with the equipment, the tractor, and all safety
practices before starting operation. Read the
safety rules and safety decals on pages 2-6.
Owner should check and tighten all hardware
after the first hour of operation. The break in
stage of your new RiataRake can cause minimal
loosening of hardware. Please see Bolt Torque
Chart (page 25) for proper torque information.
• Power unit must be equipped with ROPS or
ROPS cab and seat belt. Keep seat belt
securely fastened. Falling off power unit can
result in death from being run over or crushed.
Keep foldable ROPS systems in “locked up”
position at all times.
• Never allow children or untrained persons to
operate equipment.
• Keep bystanders away from equipment.
NEVER BACK RIATARAKE UP WITH
IMPLEMENT IN THE GROUND.
• NEVER GO UNDERNEATH EQUIPMENT.
Operation
CAUTION
WARNING