Filter
Top Products
7
LED DIAGNOSTICS
The system includes disarm diagnostics, through the RED LED light, that will help in determining what caused
the last trigger of the alarm system. This is a valuable tool in determining how the vehicle was tampered with
or if there is a false alarm problem in which case you can make the necessary adjustments to correct the
problem. When the system is disarmed with the remote you will hear the normal 2 chirps, then 4 quick chirps
that indicate the alarm was triggered while you were away. Check the LED light for a sequence of flashes:
Shock Sensor = 1 Flash Door = 2 Flashes Hood/Trunk = 3 Flashes Ignition = 4 Flashes
Diagnostics will reset when the Ignition is turned on or when the system is re-armed.
REMOTE ENGINE CONTROL
Remote Start & Auxiliary Output – Button Press Selection (Option # 8):
To eliminate the possibility of accidentally opening the trunk or starting the vehicle, there are (3) options for
button press selection. This option will allow you to change whether the Remote starter and Trunk release
activate by a:
1. Double button ½ second presses.
2. Single ½ second press.
3. Press and Hold 2 seconds.
*Default = Single ½ second press*
REMOTE ENGINE STARTING - SUCCESSFUL START
1) Press and release the remote start button on the remote transmitter. System will chirp 3 times for audible
confirmation. (Chirps can be programmed on or off-See Option programming in the installation manual.)
2) Parking lights flash once, then turn on solid, Ignition/Accessory circuits turn on.
3) After 6 seconds Starter Motor engages, Parking lights and Accessory circuits turn off while cranking.
4) Engine Starts and Runs. Parking Lights and Accessory turn back on, Doors Lock.
5) Engine will remain running for programmed run time until reset with Brake pedal. If needed, the engine can
be turned off with remote transmitter.