Filter
Top Products
12
OPTIONAL TURBO TIMER MODE
The optional Turbo Timer mode allows the system to keep a Turbo or Turbo Diesel vehicle running for 1 to 5
minutes [selectively] after you remove the key and exit the vehicle. This is handy for turbo cool-down without
the need for expensive turbo timers. This mode requires the use of an extra part called a momentary
switch/button that is not included with the kit. There are (3) modes of operation for the Turbo Timer Mode.
Option # 30 selects the Turbo Timer Mode.
1. Brake Pedal Set Mode. With the engine running by key, press Remote Start Button with brake pedal
depressed. As you release the brake pedal, the Parking Lights and Status LED will blink the number of
minutes for the Turbo Timer setting. The doors unlock after confirmation. The run time can be changed
by using the push button switch attached to the green start activation wire (see Always Set Mode).
2. Always Set Mode (default). The Turbo Timer Run Time must always be set. With brake pedal
depressed and engine running by key, Press the “Turbo Timer” button 1 to 5 times for each minute of
run time you desire. (1 press = 1 min.) As you release the brake pedal, your system will confirm by
flashing the lights the same number of times the button was pressed. The doors unlock after
confirmation. Turn Ignition switch OFF, remove key and exit the vehicle.
3. Idle Down Mode. This replaces the normal Idle Down Mode. Can’t use Infinity Run or Manual
Transmission Mode with this option. With the engine running by key, press the Remote Start
Button. The Parking Lights and Status LED will blink the number of minutes for the Turbo Timer setting.
The doors unlock after confirmation. The run time can be changed by using the push button switch
attached to the green start activation wire (see Always Set Mode).
Note: Mode 1 and 3, the run timer (1 to 5 min.) is set one time. The system always remembers the Turbo
Timer setting even with battery disconnection.