Filter
Top Products
6
OPERATING INSTRUCTIONS - ALARM
Remote AUX. Output 2 (Optional)
This system contains a second auxiliary output to activate other accessories or devices. To activate the
systems’ Second Auxiliary Output, Press button 6, then press button 1. Output stays on as long as the button
is held. Remote output #2 requires programming before operation. Check with your installer or follow
programming option instructions in the installation manual.
Remote AUX. Output 3 and 4 (Optional)
This system also has two programmable auxiliary outputs to activate other accessories or devices. To
activate Auxiliary Outputs 3 and 4, Press button 6 then press button 2 or 4. These outputs can be
programmed for momentary, timed or latched On/Off. Check with your installer or follow programming option
instructions in the installation manual.
Emergency Override (Disarm)
If the transmitter is lost or it stops working for any reason and the Alarm is armed, you will have to disarm the
system manually. Open the door with the key [alarm will sound], turn the ignition on, and press the override
program button for about 5 seconds. The Alarm will disarm and allow you to use the vehicle until you can
replace the remote. Note that you may need to put the system into valet mode to prevent passive arming.
Valet Mode (Enter manually or using the remote)
To disable Alarm and Remote Engine Starting for vehicle servicing or otherwise the system must be disarmed.
Turn the ignition on and press the override/program button [about 5-7 seconds] until you hear (3) siren chirps
and the LED turns on solid. Repeat the process to exit VALET mode. To enter / exit valet via the remote,
press and hold both buttons #1 (Lock) and Button #2 (unlock) together for about 3 seconds until 3 chirps are
heard. Repeat this step to exit via the remote transmitter. Lock/Unlock and AUX features will still operate in
when in VALET mode however remote start and alarm functions are inhibited.
Valet Park Mode (Using the remote transmitter only)
Note: Valet Park mode is only accessible when using the remote transmitter. Valet park mode allows you to
turn over the vehicle to a valet allowing access to drive/lock/unlock your vehicle, but alarm will trigger if the
trunk is opened. To activate Valet Park the system must be disarmed. Press and hold both buttons #1 (Lock)
and Button #2 (unlock) together for about 3 seconds. 3 chirps will be heard first when unit goes into regular
Valet. Release, press and hold both buttons again, you will hear 2 more chirps. LED will flash slowly when in
Valet Park. Repeat step to exit Valet Park mode.