Filter
Top Products
8
OPTION PROGRAMMING
1. Turn the Ignition ON and press the Override/Program button 5 times. After a slight delay, the system will chirp and
flash the lights 5 times.
2. Within the next few seconds, press the Override/Program button [again] the number of times that corresponds to
the feature list below. The siren and horn will chirp for each button press. DO NOT LOSE COUNT!!
3. When you get to the desired option number, quickly press the appropriate button on the remote control according to
the chart below. Button 1 gives a single light flash / chirp, Button 2 gives two light flashes / chirps, and Button 3
gives three light flashes / chirps.
4. Turn Ignition Off. System chirps and flashes the lights 3 times on exit. When you are finished customizing options,
check operation.
PROGRAMMING OPTIONS CHART * = Default Settings
Option #
OPTION DESCRIPTION
BUTTON 1
LOCK
BUTTON 2
TRUNK
BUTTON 3
SILENT X
1.
Factory Horn Chirps Pulses
Pulse with trip
only
Arm Disarm Chirps
& Pulse with trip
*Arm Disarm Warn Chirp
& Pulse with trip
2.
Passive Arming / ON *OFF*
3.
Ignition Controlled Locks *ON* OFF Lock Only (no unlock)
4.
5/60 Second
Door Open Warning
5 Sec. *60 Sec.*
5.
Active Re-Arm *Enabled * Disable
6.
Double Unlock Pulse *Disabled * Enable
7.
Disarm with trunk pop Disable *Enabled*
8.
Door Lock Pulse Time *0.75 Sec.* 3 Sec.
9.
Type of Carjack Protection *Active * Active & Passive Full-Time
10.
Carjack Feature *Disabled * Enable
11.
Parking Lights on with disarm *Enabled * Disable
12.
Passive Lock ON *OFF*