Filter
Top Products
T6991a-0920
13
20
• If the clip is upside down or not through both holes in
the axle, you have not assembled it properly. Please
remove the clip and go back to step 18.
CORRECT
INCORRECT
INCORRECT
ASSEMBLY
• Insert the "T" fastener end of a short seat belt strap
down through the slot near the outer edge of the
seat. Make sure the fastener side of the seat belt
faces inward.
Note: You will pull only one T-Loop through the slot.
• Repeat this procedure to assemble the other short seat
belt strap.
• Insert each fastener end of the long seat belt strap up
through the slots in the center of the seat. Make sure
the fasteners face the outer edge of the seat.
• Pull each side of the long seat belt strap evenly
through the slots. Make sure to pull each T-loop
through a slot.
22
Short Seat Belts
Long Seat Belt
• Align the tabs on a hubcap with the slots in a rear
wheel. “Snap” a hubcap into the center of the
rear wheel.
Hint: If the hubcap does not "snap" into place, you may
not have assembled the wire clip properly. Remove the
wire clip and refer back to step 18.
• Repeat steps 17 - 21 to assemble the other rear wheel,
wire clip and hubcap.
21
Hubcap