Filter
Top Products
Fill to 6–14 mm (1/4–9/16 inch) below bottom of filler hole.
4
Ensure the correct automatic transmission fluid is used for a specific
application. Check the container to verify the fluid is MERCON
approved. Transmission fluid requirements are indicated on the dipstick
handle. Refer to the Scheduled Maintenance Guide.
Do NOT use any non-approved automatic transmission fluid for an
application specifying MERCON. Use of a non-approved fluid may cause
internal transmission component damage.
5
Indicates only approximate dry-fill capacity. Some applications may
vary based on cooler size and if equipped with an in-tank cooler. The
amount of transmission fluid and fluid level should be set by the
indication on the dipstick’s normal operating range.
6
Add 118 ml (4 oz.) of additive friction modifier C8AZ-19B546-A, Ford
specification EST-M2C118–A, for complete fill of 8.8 inch and 9.75 inch
Traction-Lok axles.
7
Add 236 ml (8 oz.) of additive Friction Modifier C8AZ-19B546-A, Ford
Specification EST-M2C118-A, for complete fill of 10.25 inch Traction-Lok
axles.
8
In-vehicle refill: approximately 3.1L (6.5 pints).
LUBRICANT SPECIFICATIONS
Item
Ford part
name or
equivalent
Ford part
number
Ford
specification
Front axle
(4X4)
Motorcraft SAE
75W90 Axle
Lubricant
XY-75W90-QL WSP-M2C201-A
Rear axle
Motorcraft SAE
75W140 High
Performance
Synthetic Rear
Axle Lube
1
F1TZ-19580-B WSL-M2C192-A
Brake fluid and
clutch fluid
High
Performance
DOT 3 Motor
Vehicle Brake
Fluid
C6AZ-19542-AB ESA-M6C25-A
and DOT 3
Capacities and specifications
217