Fisher-Price W9257 Motorized Toy Car User Manual


  Open as PDF
of 24
 
22
W9257pr-0920
PROBLEM
POSSIBLE
CAUSE
SOLUTION
Shortruntime(Lessthan
1-3hourspercharge)
Underchargedbattery Chargethebattery.Anewbatteryshouldhavebeen1-3hoursper
charge)chargedforatleast18hoursbeforeusingthevehiclefor
thersttime.Afterrst-timeuse,rechargethebatteryforatleast
14hoursaftereachuse.Neverchargethebatterylongerthan
30hours.
Checkallwiresandconnectors.Makesurethebatteryconnector
istightlypluggedintothechargerconnector,andthatthecharger
ispluggedintothewall.
Makesurepowerowtothewalloutletis“ON”.
Overchargedbattery Donotchargethebatterylongerthan30hours.Ifyoususpect
thatyourbatteryisdamagedasaresultofovercharging,contact
ConsumerRelations.Theycantestthebatteryforyou.
Batteryisoldandwillnot
acceptfullcharge
Evenwithpropercare,arechargeablebatterydoesnotlastforever.
Averagebatterylifeis1to3yearsdependingonvehicleuseanduse
conditions.ReplaceonlywithaPowerWheels®12Voltbatterywith
built-inthermalfuse.Do not substitute parts.
Trippedthermalfuse Thebuilt-inthermalfusemay“trip”andshutdownoperationof
thevehicleifthevehicleisoverloadedorthedrivingconditions
toosevere.Onceafusehas“tripped”,removeyourfootfromthe
pedalandwait25secondsbeforeopperatingthevehicleagain.To
avoidrepeatedautomaticshutdowns,donotoverloadthevehicle
byexceedingthe130lbs(59kg)maximumweightcapacityorby
towinganythingbehindthevehicle.Donotdriveuphillsorrun
intoxedobjects,whichcancausethewheelstostopspinning
whilepowerisstillbeingsuppliedtothemotors.Ifathermalfuse
continuallytrips,contactyourlocalPowerWheels®authorized
servicecenter.
Vehiclerunsinlowspeed
butdoesnotrunin
highspeed
Please Note: The vehicle is
designed to operate in low
speed only in reverse
R
.
Highspeedlock-outnot
disconnected
Thevehiclewaspre-settorunonlyinlowspeed.Toallowthevehicle
toruninlowandhighspeed,youmustdisconnecttheHighSpeed
Lock-Out.FollowtheinstructionsintheVehicleOperationsectionto
removetheHighSpeedLock-Outscrew.
Whenthefootpedalis
pressedonlyonerear
wheelspins
Operationofvehiclein
lowspeed
Itispossiblethatonlyonerearwheelmayspinwhenbothrear
wheelsareraisedoffthegroundandthevehicleisinlowspeed.This
doesnotnecessarilyindicateaproblem.Checkforproperoperation
ofthedrivesystembyraisingtherearwheelsoffthegroundand
pressingthefootpedal.Ifonlyonerearwheelspins,carefullypress
yourhandonthespinningwheeltoslowitdown.Theotherrear
wheelshouldbegintospin.Iftheotherrearwheeldoesnotbegin
tospin,theremaybeaproblemwiththevehicle.Contactyourlocal
PowerWheels®authorizedservicecenterfordiagnosisandrepair.
PROBLEMS AND SOLUTIONS GUIDE
 previous next