Filter
Top Products
P8990a-0920
• Face the front end of the vehicle.
• Slide a
7
/16" washer onto one of the front axles.
• Slide a round bushing, ring end first, onto the front axle.
• Slide a wheel (ribbed side first) onto the front axle.
• Slide a hubcap (indented side out) onto the front axle.
• Fit a .437 cap nut on the end of the front axle.
• Fit the cupped end of the cap nut assembly tool over the cap
nut. Tap the end of the cap nut assembly tool with a hammer
to secure the cap nut on the end of the axle.
• Repeat this procedure to assemble a
7
/16" washer, round
bushing, wheel, hubcap and cap nut to the other front axle.
• Slide a
7
/16" washer onto the rear axle.
• Slide the rear wheel driver onto the rear axle. Make sure the
rear wheel driver fits onto the pins in the motor assembly.
• Slide a wheel onto the rear axle. Make sure the ribs on the
wheel fit into the grooves on the rear wheel driver.
• Slide a hubcap, indented side out, onto the rear axle.
• Fit a .437 cap nut on the end of the rear axle.
• Fit the cupped end of the cap nut assembly tool over the cap
nut. Tap the end of the cap nut assembly tool with a hammer
to secure the cap nut on the end of the rear axle.
Hint: You may need the help of another adult to support the
other end of the rear axle while you tap the cap nut assembly
tool with a hammer.
4
10
ASSEMBLY
5
P8990a-0920
7
/16" Washer
Rear Wheel
Driver
Cap Nut
Cap Nut
Assembly Tool
Hubcap
Motor Assembly
Rear Axle
Ring End
Wheel
Round
Bushing
7
/16"
Washer
Hubcap
Cap Nut
Assembly
Tool
Cap Nut
Front Axle