Fisher-Price K4563 Motorized Toy Car User Manual


 
PROBLEMS AND SOLUTIONS GUIDE
26
K4563pr-0922
P
PROBLEM POSSIBLE CAUSE SOLUTION
Vehicle runs in low speed, but
does not run in high speed.
Please note: The vehicle is
designed to operate in low speed
only in reverse.
High speed lock-out not disconnected. The vehicle was pre-set to run only in low speed. To allow the vehicle
to run in low and high speed, you must disconnect the High Speed Lock-
Out. Follow the instructions on page 22 to remove the High Speed Lock-
Out screw.
When the foot pedal is pressed
one rear wheel spins
Operation of vehicle in low speed It is possible that only one rear wheel may spin when both rear wheels
are raised off the ground and the vehicle is in low speed. This does not
necessarily indicate a problem. Check for proper operation of the drive
system by raising the rear wheels off the ground and pressing the foot
pedal. If only one rear wheel spins, carefully press your hand on the
spinning wheel to slow it down. The other rear wheel should begin to spin.
If the other rear wheel does not begin to spin, there may be a problem
with the vehicle. Contact your local Power Wheels
®
authorized service
center for diagnosis and repair.
Sometimes the vehicle doesn’t run,
but other times it does
Loose wire or connector Check all wires around the motors and all connectors to make sure they
are tight.
Motor or electrical switch damage Contact your local Power Wheels
®
authorized service center for diagnosis
and repair.
When the go foot pedal is
pressed, the vehicle won’t run
without a push
Loose wire or connector Check all wires around the motors and all connectors to make sure they
are tight.
“Dead Spot” on motor Contact your local Power Wheels
®
authorized service center for diagnosis
and repair.
Battery's thermal fuse constantly
"trips", but the vehicle is not
overloaded nor the driving
conditions too severe
Damaged battery Contact your local Power Wheels
®
authorized service center for diagnosis
and repair.
Child is switching between FORWARD and
REVERSE without stopping
Teach your child to stop the vehicle before switching direction.
Loud clacking or grinding noise
from a motor-gearbox
Broken gears Contact your local Power Wheels
®
authorized service center for diagnosis
and repair.
Charger gets warm during use It is normal for some chargers to get warm
during use and is not reason for concern.
No action required.
If your charger does not get warm during use, it does not mean that it is
not working properly.
Battery makes a sizzling or
gurgling noise when charging
It is normal for some batteries to make noise
and swell slightly while charging and is not
reason for concern.
No action required.
If your battery does not make noise or swell slightly during charging, it
does not mean that it is not accepting the charge.