Fisher-Price C0727 Motorized Toy Car User Manual


 
7
Battery Charging
E
CAUTION
Use the charger in dry locations only.
WARNING
Battery can fall out and injure a child if
vehicle tips over. Always use battery
clamp.
PREVENT FIRE
- Never modify the electrical system.
Alterations could cause a fire resulting
in serious injury and could also ruin the
electrical system.
- Use of the wrong type battery or
charger could cause a fire or explosion
resulting in serious injury.
- Use of Power Wheels
®
components in
products other than Power Wheels
®
vehicles could cause overheating,
fire or explosion.
The battery must be handled by adults
only. The battery is heavy and contains
sulfuric acid (electrolyte). Dropping the
battery could result in serious injury.
Never allow children to charge the battery.
Battery charging must be done by adults
only. A child could be injured by the
electricity involved in charging the battery.
Never lift or carry the battery by the wires
or connector. This can damage the battery
and possibly cause a fire resulting in
serious injury. Lift and carry the battery by
the case only.
Read the safety instructions on
the battery.
Examine the battery, charger and their
connectors for excessive wear or damage
each time you charge the battery. If dam-
age or excessive wear is detected, do not
use the charger or the battery until you
have replaced the worn or damaged part.
About Thermal Fuses
Your Power Wheels
®
6 volt battery is equipped with a
built-in thermal fuse. The thermal fuse is a self-resetting
safety device which automatically “trips” and shuts down
operation of the vehicle if the vehicle is overloaded or the
driving conditions too severe. Once a fuse has “tripped”,
it will automatically reset itself after approximately
25 seconds and allow the vehicle to resume normal
operations. To avoid repeated automatic shut-downs,
do not overload the vehicle by exceeding the 50 lbs
(22.5 kg.) maximum weight capacity or by towing anything
behind the vehicle. Avoid severe driving conditions, such
as driving up slopes or running into fixed objects, which
can cause the wheels to stop spinning while power is still
being supplied to the motors. Make sure your child stops
the vehicle before switching speeds or direction.
If a thermal fuse in a battery continually trips under
normal driving conditions, please contact your local
independently owned and operated Power Wheels
®
Authorized Service Center. For the location of the
nearest you, visit us on-line at www.powerwheels.com.
IMPORTANT!
• Your new battery must be charged for at least
18 hours before you use it in your vehicle for
the first time.
• We recommend that you start charging your battery
before beginning assembly of your new vehicle.
• The battery must be upright while charging.
• The charger is not a toy.
• Do not short circuit the battery.
• If your battery is old and will not accept a charge, do not
leave it in the vehicle. Always remove a dead battery
from the vehicle.
• Once installed, you do not need to remove the battery
from your vehicle to recharge it.
• Before charging the battery, examine the battery case
for cracks and other damage which may cause sulfuric
acid (electrolyte) to leak during the charging process.
If damage is detected, do not charge the battery or use
it in your vehicle. Battery acid is very corrosive and can
cause severe damage to surfaces it contacts.
• Do not charge the battery on a surface (such as kitchen
counter tops) which could be damaged by the acid
contained inside the battery. Take precautions to
protect the surface on which you charge your battery.
• Use only a Power Wheels
®
Type H 6 volt charger
(120 VAC, 60 Hz, 12W with an output of 6 VDC 4.8W
800mA) to charge your Power Wheels
®
Type H
6 volt battery.
ELECTRICAL HAZARD