Filter
Top Products
17
®
• Lift the hood.
• Place the battery in the battery compartment. Make
sure the battery connector extends toward the motor
harness connector.
Battery
Motor
Harness
Connector
Hood
Battery
Connector
®
• Squeeze the tabs on each side of the motor harness
connector. Plug the battery connector into the motor
harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again. Do not force
the battery connector into the motor harness connector.
Motor
Harness
Connector
Battery
Connector
• Fit the battery clamp (engine cover) over the battery,
motor harness connector and battery connector.
• Insert two #8 x 18 x 1" screws into the holes in the
battery clamp (engine cover) and tighten.
Battery Clamp
(Engine Cover)
• Lower the hood. Lift the hood latches and fit the short
tabs onto the notches on the hood to fasten it.
Hood
Hood
Latches
Battery Installation and Battery Clamp
(Engine Cover) Assembly
H
IMPORTANT! Use only a Power Wheels
®
Type H 6 Volt
battery. Use of any other battery will damage your vehicle.
Make sure that you charge the battery for at least 18 hours
using the enclosed Power Wheels
®
Type H 6 Volt charger
before operating your vehicle for the first time. Charge the
battery for at least 14 hours after each use of the vehicle.
Never charge the battery longer than 30 hours. Failure to
follow these instructions may damage your battery and will
void your warranty.
1
2
3
4