Filter
Top Products
Assembly
•Insert two #8 x
3
/
4
" screws through the windshield hinge
and into the windshield.
•Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
15
T
M
•Note the location of six tabs and one peg on the windshield.
•First insert the tab on the side of the windshield (that is
opposite the door) into the slot in the vehicle body.
•Then fit the remaining five tabs and peg on the windshield
into the slots and hole in the vehicle body.
•When you are sure all six tabs and one peg are inserted,
push down on the windshield to snap the tabs in place.
17
15
Windshield
Windshield
Hinge
Peg
Windshield
Tabs
IMPORTANT!
Insert side tab into
this slot FIRST
•Cut label #34 from the large label sheet.
•Position the windshield upright, as shown.
•Remove the backing and position the label on the right
side of the windshield, as shown.
Hint: Align the dotted line on the label with the back edge
of the windshield.
•Fold the back end of the label around the back edge of
the windshield.
16
Fold around
back edge of
windshield
14
•Turn the windshield face down on a
flat surface.
•Fit the windshield hinge to the
corner of the windshield.
Windshield
Windshield Hinge
See
Inset
Label 34
Tabs
Back Edge
of Windshield
Dotted Line
73517a-0920 Barbie VW 11/27/01 11:09 AM Page 15