Filter
Top Products
Assembly
13
8
•Fit the driver onto the end of the rear axle.
•Align the ribs on the inside of the driver with the gearbox
teeth. Fit the driver to the gearbox.
•Fit another wheel (with a round bushing inserted) onto the
end of the rear axle. Make sure the outside of the wheel
(smooth side) faces out and the ribs on the inside of the
wheel fit in the grooves in the driver.
•Fit a rectangular bushing, base side out, onto the rear axle.
•Push the rectangular bushing so that it fits into the
rectangular opening in the wheel.
•Fit a hubcap to the outside of the wheel. Make sure the
peg on the hubcap fits into the small hole in the outside of
the wheel.
•Fit a round bushing, barrel side first, into the hole in the
vehicle body rear wheel well, as shown.
•Slide a large washer onto the rear axle assembly.
•Slide a spacer onto the rear axle assembly.
•Fit the rear axle assembly through the round bushing and
into the hole in the vehicle body rear wheel well.
7
Barrel Side
Round
Bushing
Spacer
Large
Washer
Rear Axle
Assembly
Rear Wheel Well
Rear Axle
Driver
Outside of Wheel
Rectangular
Bushing
Rear Axle
Driver
Grooves
Peg
Small
Hole
Hubcap
Gearbox
Teeth
9
Rectangular
Bushing
Round Bushing
Base
73517a-0920 Barbie VW 11/27/01 11:09 AM Page 13