Filter
Top Products
13 By Firstech, LLC By Firstech, LLC 12
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following those three flashes the parking lights will
flash again corresponding to the error table.
We recommend that you do not attempt any repairs on your remote starter. Contact your dealer or call us directly.
Number of Parking Light Flashes Remote Start Error
1Motor running
2 Key in ignition on position
3 Door open (manual transmission only)
4 Trunk open
5 Foot brake on
6 Hood open
7Reservation off (manual transmission only)
8 Tach or voltage sensing failure
Remote Start Error Diagnostic
p@@Rbshledr
STEP 1: Activate Valet/Programming mode by manually turning the ignition key on and off (between the Acc & On positions) five times within
7 seconds. The vehicle’s parking lights will flash once with the successful completion of this step.
STEP 2: Within a 3 second period after cycling the ignition for the 5
th
time, pressing the button once for 0.5 seconds. The parking lights will
flash once to confirm the transmitter has been coded.
Exiting Programming: Programming is a timed sequence. The parking lights will flash twice signaling the
end of programming mode.
Programming Multiple Remotes: After the confirmation flash given in step 2, code additional remotes by
pressing the button on remote. The parking lights will flash once confirming each additional remote. All systems
can recognize up to three remotes.
IMPORTANT: Every CompuStar remote must be coded to the system prior to performing any operations. Remote coding is typically done at your local
CompuStar dealer.
Remote Coding / Programming Routine (S)