Filter
Top Products
By Firstech, LLC 10
General System Functions
t@r
Hold the lock/unlock button for 2.5 seconds to release the trunk or hatch. If you are in range, the remote will beep twice and the LED
flash twice indicating that the trunk release command has been successfully transmitted.
IMPORTANT : Trunk release is an optional vehicle feature that may require additional parts and labor.
General System Functions
s@v@
The optional Secure Valet Switch prevents the remote start from being put into valet mode through cycling the ignition on/off five times. The Secure
Valet Switch is more secure than traditional toggle / valet switches because it requires a two digit code. Follow the below procedures to program your
secure valet pass code:
STEP 1: Turn on Option 3-10-III. (Dealer programmed option)
STEP 2: Turn ignition key to the “on” position.
STEP 3: Hold down the valet switch for 1.5 seconds. The LED on the valet switch will begin to flash rapidly with successful completion of this step.
STEP 4: Enter the first digit of the desired two digit pass code by depressing the switch the number of times that coordinates with the desired first
number. For example, to enter 3, depress the switch 3 times, then wait.
STEP 5: The LED will confirm the first number by flashing BLUE slowly. Once the LED begins to flash rapidly, enter your second number by
repeating step 4.
STEP 6: Turn the ignition off - the Secure Valet Switch is now programmed. Follow steps 3 - 5 to enter your Secure Valet code.
a@o@O@w@r@d@O@s@d
Your system is equipped with one additional output that can be configured to control windows, open power sliding doors, open a power sliding
moon roof, or even turn on a rear defroster. These outputs can be configured for pulsed, timed or latched settings. Your authorized CompuStar
dealer can set these outputs up accordingly. Using the auxiliary output to control additional vehicle functions will require additional parts and can be
rather labor extensive.
Tap the key/start button for 0.5 seconds to trigger auxiliary output 1. The remote will beep once and LED flash once indicating that
the auxiliary output has been triggered.
By default, the system is in secure auxiliary mode. This feature must be turned off to use auxiliary 1 with the P2BSHLEDR. To turn off secure
auxiliary, ask your authorized CompuStar dealer to turn on Option 4-5 to setting II
a@g@O@s@k
The optional anti-grind/starter kill feature prevents you from accidentally grinding your vehicle’s starter motor when taking over with the key. This
feature requires additional installation and programming. Also your dealer can program a basic security feature that prevents your vehicle from
starting when it is locked/armed. Please see your dealer for more details.
11 By Firstech, LLC