Filter
Top Products
7 By Firstech, LLC By Firstech, LLC 6
Quick Reference
The only regular maintenance this system requires is remote control battery replacement. No programming is required when replacing
the battery.
Two-Way Remote: 2BSHLEDR
First, remove the two small screw covers and Phillips screws located on the back of the remote. Once the screws have been removed, gently pull the
remote apart being careful to not touch the circuit board. The 2BSHLEDR requires two CR2025 batteries. These specialty batteries can be purchased
from your local CompuStar dealer or an electronics store.
r@mMb@r
Button Duration Additional Programming Required Function / Description
0.5 seconds no Lock/Arm. Tap again to Unlock/Disarm the vehicle
2.5 seconds no Trunk pop. Triggers the trunk release output and opens the vehicles trunk.
0.5 second Yes, POC Programming
2.5 seconds no Activates the remote start. Repeat and remote start will shut off.
0.5 seconds no Valet mode (see above for details)
2.5 seconds no Panic mode. Honks horn and flashes parking lights. (Optional)
R@b@r@f
General System Functions
The remote transmitter functions have been predetermined and programmed from the factory. The dual button configuration allows for keyless entry
and/or remote start functionality as well as a few other functions. Although other CompuStar systems have numerous button functions and capabilities,
please keep in mind that your system has the option for future upgradeability to a 2 Way system with a liquid crystal display.
Sending Commands
When in range, and the button has been pressed, the remote will beep, bright blue LED will illuminate, and vehicle’s parking lights will flash. For
example, to send a remote start command from the 2BSHLEDR, hold down the key/start button for 2.5 seconds. The remote will beep and bright blue
LED will come on solid and then flash.
Receiving Commands
The remote pager will receive beep and bright blue LED flash confirmation indicating confirmation of sending commands. For example, after sending the
lock command, the pager will be beep and flash the LED once to confirm the vehicle has been successfully locked/armed.
Tap the lock/unlock button for 0.5 seconds to lock/arm and unlock/disarm. The remote bright blue LED will flash twice indicating
the signal has been sent to the vehicle. Upon confirmation of lock/arm or unlock/disarm the remote will beep and flash the LED once
or twice respectively. This feature is optional and may require additional programming and/or installation. Please check with your
dealer for details.
a@lOa@@uOd
+
Aux 1. Triggers the auxiliary 1 output
(most commonly used for rear defrost or window roll-down).