Filter
Top Products
Page 9
“Edit” Mode Screens for
MG2000 J1939 Tachometer
Enter the “Edit” mode from “Normal”
mode by pressing and holding the “Mode”
button and the “Up” button for approx.
2 seconds The first editable screen
will appear. By repeatedly pushing and
releasing the “Down” button, the screens
will advance to the next editable screen
in the order defined below. To go back to
a previous screen, press and release the
“Up” button.
If no buttons are pushed within 40
seconds the system will exit the “Edit”
mode and revert back to the “Normal”
mode. “Normal” mode is defined as the
mode entered after power up.
Edit Mode
The “Edit” mode is used to adjust or set
the values of numerous functions and
options in the MG2000. The procedure
below specifies the steps to be taken in
the “Edit” mode to adjust / set each option.
To enter “Edit” mode, press the “Mode”
and “Up” buttons while in “Normal” mode.
To return to “Normal” mode, press the
“Mode” button once while in “Edit” mode.
Functions that are set or adjusted in the
“Edit” mode.
1. Select Default Screen
2. Reset Fuel Used
3. Set Fuel Tank Full
4. Set Amount Of Fuel
5. Organize User Screens
6. Select Gauge Range
7. Select Fuel Sender
8. Select Display Units
9. Select Fuel Tank Size
10. Fuel Tank Calibrate
11. Low Fuel Alarm
12. Select Self Test
13. Software Id and Revision of J1939
(Info only screen)