Filter
Top Products
I / P.(l]+lJ:| ! ::_']"[.Iei t I+[_
Performance probtems often can be corrected by the user. Please read through this
chart for a possible solution to common problems.
PROBLEM POSSIBLE CAUSE SOLUTION
The battery is connected The charger is in tester
and the charger is on, mode, not charger mode.
but isn't charging.
indicator lights are lit in You might have acciden-
an erratic manner not tally activated a special
explained in the "Using diagnostic mode.
Your Battery Charger"
section.
The CHECK (red) LED
always flashes before
the battery is completely
charged.
Engine crank time is less
than specified.
The green CHARGED
LED lights a few minutes
after connecting to the
battery.
The incorrect BATTERY
TYPE may have been
selected.
This will happen if the
battery did not reach fuII
charge within 24 hours.
May be due to a very
large battery or a bank
of batteries requiring
more power than a 40/15
Amp charger can deliver
within 24 hours. The bat-
tery may also be faulty.
Starter motor may be
drawing more than 125
Amps.
The battery may be
fuNy charged or recently
charged, teaving the bat-
tery voltage high enough
to appear to be fully
charged.
The incorrect BATTERY
TYPE may have been
selected.
Press the CHARGE
RATE button to activate
charging and select a
charge rate.
Make sure nothing is
touching the control
panel, then unplug the
charger and plug it in
again.
Reset the charger by un-
plugging it or briefly dis-
connecting the negative
battery clip. Select the
desired CHARGE RATE
and BATTERY TYPE
again, if necessary.
Charge the battery at
the 40A rate for 10 to 15
minutes then crank the
engine.
If the battery is in a ve-
hicle, turn the headlights
on for a few minutes
to reduce the battery
voltage and try charging
again.
Reset the charger by un-
plugging it or briefly dis-
connecting the negative
battery clip. Select the
desired CHARGE RATE
and BATTERY TYPE
again, if necessary.
t5