Filter
Top Products
©2007 Edelbrock Corporation
Brochure #63-0478
Catalog #70410
Rev. 7/07 - DC/mc
Page 9 of 16
2.6 Nitrous Plate Installation
1. Disconnect the throttle body from the intake manifold by removing the two nuts from the studs on the lower portion
of the throttle body and removing the two bolts from the upper portion of the throttle body.
2. Remove the two studs from the intake manifold.
3. Place the nitrous plate in between the throttle body and intake manifold with the nitrous inlet facing up as pictured
below.
4. Place the supplied gasket in between the nitrous plate and throttle body. The nitrous plate to intake manifold side
does not require a gasket because the intake manifold has an o-ring. Be sure the o-ring is seated correctly.
5. Using the four supplied bolts, bolt the throttle body/plate assembly to the intake manifold.
2.7 Fuel Pressure Take-Off Adapter Installation
1. Disconnect the connector for the fuel rail pressure sensor.
2. Remove the two screws mounting the fuel rail pressure sensor and carefully lift the sensor out of its seat.
3. Install the supplied o-ring on the adapter that comes in the kit. Lubricate the o-ring with a little fuel from the rail.
4. Carefully push the adapter nipple into the port of the fuel rail, being careful not to tear the o-ring. A slight twisting
motion usually helps with the installation.
5. Using the same method as above, install the fuel
rail pressure sensor into the top of the adapter.
6. Using the supplied bolts and washers, tighten the
assembly down.
7. Using Teflon paste, install the 4AN to 1/8”NPT
fitting into the front test port of the adapter.
8. Using Teflon paste, install the 1/8”NPT pipe plug
into the remaining test port on the backside of the
adapter. In the picture to the right, we have a
pressure transducer installed in the spare port. If
you are using a QuikData or other data acquisition
unit, this port can be used for a transducer.
9. Connect the 4AN fitting to the inlet fitting of your
Performer Fuel Solenoid using the supplied 3 foot
4AN fuel feed line.