Filter
Top Products
©2003 Edelbrock Corporation
Brochure No. 63-0173
Rev. 02/03
Page 13 of 23
2.8 EFI Vacuum Tee Installation
1. Install the recommended fuel jet into the EFI vacuum tee and tighten fitting securely.
2. Remove the vacuum line from the vehicle’s fuel pressure regulator.
3. Install the vacuum line from the vehicle’s fuel pressure regulator onto the center barb fitting of the EFI vacuum
tee. Note:
The center barb can easily be indentified by the anodized nut used to hold the Pressure Relief Jet.
4. Measure the correct length of vacuum line from the barb on the Fuel Pressure Regulator to one port of the EFI
vacuum tee. Cut the vacuum line and install.
5. Measure the correct length of vacuum line from the barb fitting to the nitrous pressure regulator to the
remaining open port of the EFI vacuum tee. Cut vacuum line and install.