Dodge 2011 Nitro Automobile User Manual


 
ENGINE BLOCK HEATER IF EQUIPPED
The engine block heater warms the engine, and permits
quicker starts in cold weather. Connect the cord to a
standard 110-115 Volt AC electrical outlet with a
grounded three-wire extension cord.
The engine block heater cord is found under the hood
clipped to the heater line on the left side of the engine.
The engine block heater must be plugged in at least one
hour to have an adequate warming effect on the engine.
WARNING!
Remember to disconnect the engine block heater
cord before driving. Damage to the 110-115 Volt AC
electrical cord could cause electrocution.
AUTOMATIC TRANSMISSION
CAUTION!
Damage to the transmission may occur if the follow-
ing precautions are not observed:
Shift into PARK only after the vehicle has come to
a complete stop.
Shift into or out of REVERSE only after the
vehicle has come to a complete stop and the engine
is at idle speed.
Do not shift from REVERSE, PARK, or NEUTRAL
into any forward gear when the engine is above
idle speed.
Before shifting into any gear, make sure your foot
is firmly on the brake pedal.
288 STARTING AND OPERATING