Filter
Top Products
Programming HomeLinkா
Before You Begin
If you have not trained any of the HomeLink buttons,
erase all channels before you begin training.
To do this, press and hold the two outside buttons for
20 seconds until the red indicator flashes.
It is recommended that a new battery be placed in the
handheld transmitter of the device that is being copied to
HomeLink for more efficient training and accurate
transmission of the radio-frequency signal.
Your vehicle should be parked outside of the garage
when programming.
•
Turn the ignition switch to the ON/RUN position.
•
Hold the battery side of the handheld transmitter
away from the HomeLink button you wish to pro-
gram.
Place the handheld transmitter 1–3 in (3-8 cm) away
from the HomeLink button you wish to program
while keeping the indicator light in view.
•
Simultaneously press and hold both the chosen
HomeLink button and the handheld transmitter but-
ton until the HomeLink indicator changes from a
slow to a rapidly blinking light, then release both the
HomeLink and handheld transmitter buttons.
Watch for the HomeLink indicator to change flash
rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you train.
NOTE:
•
Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the “Gate Operator/Canadian Programming” section.
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 167