Directed Electronics 5701 Automobile Alarm User Manual


 
© 2008 Directed Electronics—all rights reserved
27
Switch has been programmed to a new number of presses by your
authorized dealer, that number should be indicated below.
Add here:
Override Switch Number ___________
Using the remote start
Before using your Remote Start
Read this user guide, including the warnings on page 24.
Ensure that the vehicle is parked in the open air and not in a garage.
To use your remote start to pre-warm or pre-cool your vehicle, remem-
ber to set the climate controls to the desired settings before shutting
off the engine.
Remote starting your vehicle
Press the button on the remote control. The vehicle parking
lights flash.
On the 2-way remote, the Remote Start indicator blinks and ascend-
ing
Remote Start tone plays.
The preset remote start run time is 12 minutes. This can be changed to
between 12 and 60 minutes (see your authorized dealer for program-
ming changes).
Your system has a feature (if programmed on) that will automatically
notify you when the run time is running low. When 9 minutes (of the
12 minute default) runtime has elapsed, the system sends the 2-way
remote control a paging signal. The 2-way remote beep once, plays