Filter
Top Products
2255
The Valet/Program switch, plugged into the blue port, is used for programming. There is a basic sequence of
steps to remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1.
OOppeenn aa ddoooorr..
(The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
2.
KKeeyy..
Turn the ignition to the ON position.
3.
CChhoooossee..
Within 10 seconds, press and release the Program switch the number of times cor-
responding to the desired channel listed below. Once you have selected the channel, press
the switch once more and
HHOOLLDD
it. The LED will flash and the horn will honk (if con-
nected) to confirm the selected channel. Do not release the Program switch.
4.
TTrraannssmmiitt..
While
HHOOLLDDIINNGG
the Valet/Program switch, press the button on the transmitter
that you would like to control the selected receiver channel. The unit will chirp to confirm
that the code has been successfully programmed. It is not possible to teach a transmit-
ter button to the system more than once.
5.
RReelleeaassee..
Once the code is learned, the Valet/Program switch can be released.
You can advance from programming one channel to another by releasing the Valet/Program switch and tapping
it to advance channels and then
HHOOLLDDIINNGG
it. For instance: You have programmed Channel 1 and you want to
CCHHAANNNNEELL NNUUMMBBEERR FFUUNNCCTTIIOONN WWIIRREE CCOOLLOORR
1 Auto Learn Standard Configuration
**
(default)
2 Arm only
3 Disarm only
4 Silent Mode™/Remote Valet®/Trunk Release RED/WHITE
5 No function
6 Channel 4 VIOLET/BLACK
7 Channel 5 WHITE/BLACK
8 No function
9 No function
10 Arm/Disarm/Panic
11 Panic only
12 Delete all transmitters
**NNOOTTEE::
For Auto Learn Configurations, see Transmitter Configurations section of this
guide.