Filter
Top Products
1166
As shipped, this wire should be connected to the (+) parking light wire. If the light flash polarity jumper under
the sliding door is moved to the opposite position (see
Internal Programming Jumper
section of this guide), this
wire supplies a (-) 200 mA output. This is suitable for driving (-) light control wires in Toyota, Lexus, BMW, some
Mitsubishi, some Mazda, and other model cars.
((++)) PPoossiittiivvee LLiigghhtt FFllaasshh OOuuttppuutt
((--)) LLiigghhtt FFllaasshh OOuuttppuutt
NNOOTTEE::
For parking light circuits that draw 10 amps or more, the internal jumper must be
switched to a (-) light flash output. (See the Internal Programming Jumper section of this
guide.)
PP//NN 88661177
or a standard automotive SPDT relay must be used on the H1/2 light flash
output harness wire.
HH11//22 WWHHIITTEE ((++//--)) sseelleeccttaabbllee lliigghhtt ffllaasshh oouuttppuutt