Filter
Top Products
33
©
2001 Directed Electronics, Inc.
QUICK REFERENCE GUIDE:
To arm using your remote
■ You can activate, or arm, the system by pressing on your trans-
mitter for one second. When the system arms, you will hear a short siren
sound, or chirp, and the parking lights will flash once. If the vehicle’s
power door locks have been connected to the system, the doors will
lock.
To disarm using your remote
■ To disarm the system, press again. You will hear two chirps, and
the parking lights will flash twice. If power locks are connected to the
system, the doors will unlock. If the siren chirps either four or five times
when disarming, see Diagnostics section. This is called Tamper Alert.
Arming While Driving
■ Press on your transmitter while the vehicle is running. The system
will chirp once and then once more to indicate that the ignition is on.
Disarming Without a Transmitter
■ Turn on the ignition. Push the Valet
®
switch within 15 seconds. The sys-
tem should now disarm. If it does not, you may have waited too long,
so turn the ignition off and on and try again.
To enter or exit Valet
®
Mode
■ Turn ignition to “run” position, then turn to “off” position. Press and
release the Valet
®
switch within 10 seconds. The status LED will light
solid if you are entering Valet
®
Mode, and it will go out if you are exiting
Valet
®
Mode.
To activate panic mode
■ Hold down for 1.5 seconds.
To exit panic mode
■ Press on the transmitter.
To activate Silent Mode
™
■ Press briefly before arming or disarming, and the confirmation
chirp(s) will be eliminated for that one operation only.
Cut along dotted line and fold for a quick and easy reference to keep in your purse or wallet.
✂
✂