Filter
Top Products
User guide P.11
4. Press the button; this will lock the doors, arm the OEM-style alarm (if configured|)
and confirm that the vehicle is in Turbo Mode.
5. The engine will shut down after 60 seconds.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page-5) to
activate Turbo Mode. At the last step, press either:
• to lock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
The OEM-style alarm and starter kill (if configured) will be armed.
•
to unlock the doors and have the engine shut down after 60 seconds;
The parking lights will flash 3 times and remain lit.
•
to shut down the engine without affecting the doors.
Note: The vehicle will enter Ready Mode once the engine run time expires.
“HomeValet
TM
”Mode
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the
vehicle has a manual transmission, it should be set into ready mode before activating the Home
Valet™.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote, but the
OEM alarm functions will remain active.
To take the system into home valet mode:
1. Press the or button.
2. Within 3 seconds, press the
and buttons simultaneously for 3 sec.
3. The P-lights will flash once
To take the system out of home valet mode:
• Turn the ignition key to the IGNITION ON (RUN) position.
The system will warn you if someone attempts to start your vehicle while it stands in home valet
mode. The parking lights will:
Turn ON then OFF; then
Flash twice, pause; then
Flash twice again.
AUX1
Note: This 500 mA negative Aux
1 output can be used for many different applications
Priority door:
This great feature allows the user to unlock solely the driver’s door with a single press of
the button on the transmitter, and to unlock the other doors, if desired, by pressing
the
button for a second time.
The output will provide a 1-second negative output when the
button is pressed a
second time on the transmitter.
Horn Confirmation:
AUX 1 can be programmed to trigger the horn every time the
button is pressed, or
when the
button is pressed twice within 3 seconds. When horn confirmation is