Filter
Top Products
24
© 2008 Directed Electronics. All rights reserved.
Timer Mode is exited automatically after the sixth run cycle. The parking lights
slowly ash 4 times when exiting timer mode.
Note:
The Bitwriter® can change the amount of times the remote start activates
and, it can change the intervals between activations in timer mode.
Turbo Timer mode
Turbo timer mode keeps the engine running after arriving at your destination for
a programmable period of 1, 3, 5 or 10 minutes. This allows the system’s timer
to conveniently cool down the turbo after you have left the vehicle.
The system monitors the engine speed and will automatically shut the engine off
if the RPMs rise above or fall below the programmed levels. This feature prevents
damage to the motor due to fuel delivery system failures or other problems that
may cause the engine to race
To activate Turbo Timer Mode with an automatic transmission:
Make sure the Turbo timer feature is turned on in the features grid.1.
Open the vehicle door.2.
While the vehicle is running; press the 3.
AUX
button twice followed by the
AUX
button.
The parking lights flash once and the remote plays the remote start activa-4.
tion tone confirming that the remote start is activated (the one way remote
only flashes the parking lights).
Turn off the ignition (car stays running).5.
Exit the vehicle and lock the system.6.
At this point the vehicle stays running for the programmed runtime.