Filter
Top Products
© 1999 Directed Electronics, Inc. Vista, CA 35
feature descriptions
The features of the system are described below. If the system is being programmed with a DEI® Bitwriter™ or
996T and a personal computer the options available may change. PC programmable options are indicated by the
following icon:
1-1 ACTIVE/PASSIVE ARMING: When active arming is selected, the system will only arm when the transmitter is
used. When set to passive arming, the system will arm automatically 30 seconds after the ignition is turned off.
1-2 CHIRPS ON/OFF: This feature controls the chirps that confirm arming and disarming of the system.
1-3 IGNITION CONTROLLED DOOR LOCKS ON/OFF: When turned on, the doors will lock three seconds after the
ignition is turned on and unlock when the ignition is turned off.
1-4 ACTIVE/PASSIVE LOCKING: If passive arming is selected in Menu One, Feature 1-1, then the system can be
programmed to either lock the doors when passive arming occurs, or only lock the doors when the system is armed
with a transmitter. Active locking means the doors will not lock when the system passively arms. Passive locking
means that the doors will lock when the system passively arms.
menu #1
FEATURE DEFAULT - LED ON SETTING LED OFF SETTING
NUMBER (PRESS CHANNEL 1) (PRESS CHANNEL 2)
2-1 Engine checking on Engine checking off
2-2 Tachometer checking type Voltage checking type
2-3 12 minutes run time 24 minutes, 60 minutes run time
2-4 Flashing parking light output Constant parking light output
2-5 Cranking time 0.6 sec. (1)* Cranking time 0.8 (2), 1.0 (3), 1.2 (4), 1.4 (5),
1.6 (6), 1.8 (7), 2.0 (8), 4.0 (9) sec.*
2-6 High voltage check level Low voltage check level
2-7 Auxiliary output - factory alarm disarm Auxiliary output - special accessory
2-8 Normal status output Factory re-arm output
2-9 Anti-Grind on Anti-Grind off
*NOTE: The numbers in parentheses indicate the number of times the LED will flash.
menu #2