Filter
Top Products
8
© 2010 Directed Electronics. All rights reserved.
Remote and System operations
Passive arming/locking
The system can be programmed to arm/lock itself au to mat i cal ly (called
pas sive arming/locking). If the system is programmed for passive arming/
locking, it will automatically arm/lock 30 seconds after the ignition is
turned off and the system detects that you have left the vehicle by opening
and closing a door. Whenever the system is in its 30-sec ond passive arm-
ing/locking count down, the status LED will flash twice as fast as it does
when the system is armed/locked. At the 20-second point of the count-
down, the siren/horn will sound to indicate that the system is about to
arm/lock. At the 30-second point, the parking lights will flash to indicate
that the system is armed/locked.
Note: If any protected entry point (such as a door or a switch-protected
trunk or hood) is open, the system will not passively arm/lock (unless
forced passive arming/locking is programmed on). See Programming
Options section in the expanded version of this manual online at www.
automatecarsecurity.com..
Warn away
®
response
A Warn Away Response consists of an alarm page along with the
responses described below.
• Shock Sensor - Light impacts to the vehicle will flash the vehicle
lights and sound the siren/horn for a few seconds.
Triggered response
A Triggered Response can be activated by any of the triggers listed
below. The default Triggered Response duration is 30 seconds but can
be programmed from 1-180 seconds by your installer.