Filter
Top Products
6
© 2009 Directed Electronics. All rights reserved.
To turn the rear defogger output On:
1. Simultaneously press & release the
DRW-226
+ +
DRW-226
buttons on
the remote control.
2. The lights will flash 3 times.
3. The rear defogger output will once again activate when the ve-
hicle is remote started.
Note:
If the remote start is On, the lights turn off and then flash 3-times
before returning to normal output. The defogger output activates as
programmed.
*Rear defogger must be installed and turned on by an authorized Di-
rected dealer.
➢ Valet Take-Over
The Valet Take-Over feature allows the vehicle to remain running after
the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods
of time, but would like to leave the motor running and the climate
controls on.
To perform Valet Take-Over:
1. Before turning off the engine, press and release on the remote
control for 1 second.
2. Turn the ignition key to the OFF position. (The engine will stay
running.)
3. The vehicle will run for the pre- pro gram med period of time (12,
24, or 60 minutes) or until a shutdown input is trig gered.