Filter
Top Products
5
© 2009 Directed Electronics. All rights reserved.
When you are ready to drive the vehicle:
1. Insert the ignition key and turn it to the ON (not the START)
po sition.
2. Press the brake pedal. The remote start system shuts down and the
motor continues to run because the ignition has been turned on.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine will shut down.
The system monitors the vehicle during remote start runtime operation.
The engine will automatically shutdown if the system receives any of the
following shut-down inputs:
• The brake pedal is pressed.
• The hood is opened.
• The shutdown toggle switch is put into the OFF position.
• The pre-programmed run time (12, 24, or 60 minutes) has elapsed.
• Remote control button
is pressed or optional activation input.
➢ Rear Defogger*
To turn the rear defogger output Off:
1. Simultaneously press & release the
DRW-226
+ +
DRW-226
buttons on
the remote control.
2. The lights flash 2 times.
3. The rear defogger output will no longer activate when the vehicle
is remote started.
Note:
If the remote start is On, the parking lights turn Off then flash
2- times before returning to normal output. The defogger output, if ac-
tive, will cease.