Filter
Top Products
9
© 2002 directed electronics, inc.
valet mode
You can prevent your system from automatically activating the
Failsafe
®
Starter Kill and locking the doors by using Valet
®
Mode.
This is very useful when washing the vehicle or having it serviced.
In Valet
®
Mode, the starter kill cannot be activated, even with the
transmitter, but all convenience functions (door locks, remote
start, etc.) will continue to work normally.
To enter or exit Valet
®
Mode:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet®
switch within 10 seconds.
The status LED will light steadily if you are entering Valet
®
Mode
and will turn off if you are exiting Valet
®
Mode.
panic mode
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter. Just
press for two seconds to enter Panic Mode. In Panic Mode,
the horn will honk and the parking lights will flash for 30
seconds. To stop Panic Mode at any time, press on the trans-
mitter again.
note: In order for Panic Mode to be effective, the vehicle’s
horn (or optional siren) as well as the vehicle's parking
lights must be connected.
➜
DRW-35
➜