Filter
Top Products
10
©
1999 Directed Electronics, Inc.
To enter or exit Valet Mode with
the Valet switch:
1. Turn the ignition on.
2. Turn the ignition off.
3. Press and release the Valet switch
within 10 seconds.
The status LED will light steadily if you are entering Valet Mode
and will turn off if you are exiting Valet Mode.
You can also activate Valet Mode with the remote transmitter:
1. Open any vehicle door.
2. Press .
3. Press .
4. Press again.
The status LED will light solid if you are entering Valet Mode and
will turn off if you are exiting Valet Mode.
Your system has Nuisance Prevention
®
Circuitry (NPC
™
) to prevent
annoying repetitive trigger sequences caused by faulty door pin
switches or environmental conditions such as thunder, jackham-
mers, airport noise, etc.
Here’s how it works: If the alarm is triggered by the same sensor or
switch three times within a 60 minute period, your system inter-
prets this pattern of triggers as false alarms. After the third trigger,
Nuisance Prevention
®
Circuitry
Remote Valet
®
DRW-35