Filter
Top Products
8
©
1999 Directed Electronics, Inc.
Press to disarm the security system and unlock the doors (if
connected). Disarming is confirmed when the parking lights flash
twice and the siren emits two chirps. The siren chirping either four
or five times when disarming indicates Tamper Alert, which is de-
scribed in the Diagnostics section of this manual.
This feature allows you to disarm the system without the remote trans-
mitter, in the event that the transmitter is lost, damaged or disabled.
To disarm the system without a remote transmitter, you must have
the vehicle’s ignition key and know where the Valet switch is located.
Be sure to check with your installer at the time of installation for
both the location and the preset response (1-5 presses) of the
Valet switch.
To disarm the system, turn the ignition
key on and press the Valet switch the
preset number of times within 15 sec-
onds. If the system does not disarm,
you may have waited too long; turn
the ignition off and repeat the process.
IMPORTANT: The Valet switch can be programmed to respond to 1-5
presses for the disarm function. You must check with the installer to ver-
ify the programming for your individual unit.
LOCATION OF VALET SWITCH_____________________________
DRW-35
Disarming Without a Transmitter
Disarming