Filter
Top Products
12
© 1997 Directed Electronics, Inc.
Rapid Resume Logic
This DEI security system is equipped with circuitry that will allow the unit to
remember it's alarm state if power is lost and then reconnected. If a potential
thief disconnects the battery in an attempt to disable the alarm and then
reconnects it, the security system will power up in the same state it was when
power was lost. For example, if power is disconnected during it's full trigger
sequence, when power is reconnected to the unit it will remain in the full trig-
ger sequence. If power is disconnected when the unit is disarmed, it will
power back up disarmed. This also applies to the VRS sequence. If the unit
loses power at any time during the VRS sequence, when the unit is powered
back up it will automatically go to the VRS full trigger sequence.
Programming Options
Programming options control what your system does during normal opera-
tion, and require little or no additional parts. However, some may require addi-
tional installation labor.
The following is a list of the program settings, with the factory settings in Bold.
• Active arming (only with the transmitter) or passive arming (automatic arming
30-seconds after the last door has been closed).
• Arming\disarming confirmation siren chirps on or off.
• Passive door locking (with passive arming) or active door locking (only when
arming with the transmitter). This feature only works if passive arming has
been turned on.
• The ignition controlled door lock feature on or off: With this feature on, the
doors will lock 3-seconds after the ignition is turned on, and unlock when the
ignition is turned off.The system can also be programmed to prevent the door
from locking when the ignition is turned on with any door open. If your
installer is programming the system with a personal computer and the
TechSoft Programmer, ignition lock and ignition unlock are independent features
and can be programmed separately.