Filter
Top Products
Disarming Diagnostics
Extra disarm chirps are the Tamper Alert. If four chirps are heard when dis-
arming, the system was triggered in your absence. If five chirps are heard, a
zone was triggered so many times that Nuisance Prevention Circuitry™ has
bypassed that zone. In either case, the Status LED will indicate which zone
was involved (see Table of Zones section). The system will retain this infor-
mation in its memory, and chirp four or five times each time it is disarmed,
until the next time the ignition key is turned on.
Table of Zones
The zone number is the number of LED flashes used by the system to iden-
tify that input. The standard input assignments are listed below, along with
spaces to write in any optional sensors or switches you have had installed.
NOTE: Zones 5 and 6 report to the LED when the system is disarmed. However, they are not reported by disarming
diagnostics of the siren.
10
© 1997 Directed Electronics, Inc.
Zone # of LED Flashes Description Dealer Installed Options
1
Instant–Often used for hood/trunk
pin switches
2
Instant trigger–a heavier impact detected by
the DoubleGuard
®
Shock Sensor
3
Door switch trigger
4
Instant trigger–for optional sensors
5
Warn Away trigger–a lighter impact detected
by the DoubleGuard
®
Shock Sensor
6
Warn Away trigger for optional sensor
7
Panic mode activated
8
Ignition trigger