Filter
Top Products
52
© 2003 directed electronics, inc.
Was the Tach Learn successful? The LED must light solidly
and brightly to indicate a successful learn.
Make sure that there is a tach signal right at the
purple/white tach input wire of the remote start. If not,
recheck the connection to the vehicle’s tach wire and make
sure the wire is not broken or shorted to ground leading to
the remote start.
➤ The vehicle will start and run only for about 10 seconds.
Is the remote start programmed for voltage sense? Try
programming the unit for low voltage reference. If this does
not work a tach wire should be used.