Filter
Top Products
6
©
2001 Directed Electronics, Inc.
Using Your System
The buttons described in all instructions in this manual correspond
to a standard configuration transmitter, unless otherwise specified.
You can arm the security system by pressing for one second.
When the system arms, you will hear a short siren sound (chirp)
and the parking lights will flash once. Once armed, the status LED
will flash once per second to indicate that the system is actively
protecting your vehicle. If you hear a second chirp after arming
and notice that the status LED is flashing in a grouped pattern,
this signals Bypass Notification. Bypass Notification is described in
detail in the Diagnostics section of this manual.
Your security system can also be programmed for Passive Arming.
With Passive Arming, the system automatically arms itself 30 seconds
after the ignition has been turned off and the last door has been
closed. During the 30-second Passive Arming countdown, the status
LED will flash twice as fast as it does when the system is armed.
NOTE: If any protected entry point, such as a door or switch-protected
trunk or hood, is open, Passive Arming will not engage. Additionally, each
time a sensor is triggered during the Passive Arming countdown, the
countdown starts over.
Arming your system protects your vehicle in the following ways:
■ Light impacts trigger a Warn Away
®
response, causing the siren
to chirp and the parking lights to flash for a few seconds.
Arming