Filter
Top Products
13
©
2001 Directed Electronics, Inc.
If the security system is armed while an input is active (a sensor
is triggering) the siren will chirp once when arming and then one
more time a few seconds later. This extra chirp is called Bypass
Notification.
The security system will ignore the input that was active when the
system was armed, until the input goes away. Three seconds later
the system will monitor that input normally. For example, if the
tilt switch (motorcycles only) is at an unusual angle, and you try
to arm the security system, you may hear Bypass Notification
chirps. Once the tilt switch is restored to its proper angle, the
vehicle will be monitored normally.
NOTE: Bypass Notification will not occur if the chirps have been pro-
grammed OFF.
Extra disarm chirps are the Tamper Alert. If four chirps are heard
when disarming, the system was triggered in your absence. If five
chirps are heard, a zone was triggered so many times that Nui-
sance Prevention
®
Circuitry has bypassed that zone. In either case,
the status LED will indicate which zone was involved (see the
Table of Zones section). The security system will retain this infor-
mation in its memory, and continue to chirp four or five times
each time it is disarmed, until the next time the ignition key is
turned on.
Disarming Diagnostics
Arming Diagnostics