Filter
Top Products
10
©
2001 Directed Electronics, Inc.
To disable the back-up battery siren, follow these steps:
1. Locate the back-up battery siren.
2. Remove the water protective cap on the
back side of the siren to expose the siren
lock switch.
3. Insert the siren key into the siren lock
switch and turn the key to the LEFT to
disable the back-up battery siren.
Once the vehicle battery has been reconnected or full charge is
restored, the back-up battery siren can be re-enabled.
To re-enable the back-up battery siren, follow these steps:
1. Turn the siren key back to the RIGHT.
2. Replace the water protective cap on the
back side of the siren.
WARNING! If the siren lock switch key is turned to
the enable position without the vehicle battery
being connected, the back-up battery siren will
sound.
If you are threatened in or near your vehicle, you can attract
attention by triggering the system with your transmitter! Just
press for 1.5 seconds, and you will enter Panic Mode. The
siren will sound and the parking lights will flash for the pro-
grammed siren duration. To stop Panic Mode at any time, press
on the remote transmitter again.
Panic Mode