Filter
Top Products
Page 5
WELDING
The weight rating of the coupler is dependent on
the correct bolts being used. You must use the
bolts provided with the product. If you are miss-
ing bolts, refer to your Operatorís Manual and ob-
tain replacements from Demco, or use the exact
size, grade, and number of bolts as specified. Us-
ing the wrong size, grade, or number of bolts will
reduce the weight rating of the coupler and could
cause separation of your towing equipment from
the towing vehicle. If you have questions about
the correct bolts for your application call Demco
at any of the following telephone numbers:
(712) 725-2311
(712) 725-2302
1-800-543-3626
FAX: 1-800-845-6420
WARNING: TO AVOID PERSONAL INJURY OR PROPERTY
DAMAGE, OBSERVE THE FOLLOWING INSTRUCTIONS:
!
Tack Actuator down on the
four corners then weld in a
criss cross pattern using 2î
to 2-1/2î welds with 2î
spaces between welds
(when welding down to a
flat area of the tongue)
Do not weld in the
circled area
Do not weld in the
circled area
Keep braces and welds
back to allow access to
shock pin holes
Keep braces
and welds
back to allow
access to
shock pin hole
Use gussets to sup-
port the back of the
actuator if welding in
position shown
Keep gussets
on rear of ac-
tuator to lower
half to avoid
circled area
Weld as shown
NOTE: disassembly of the actuator before welding is recommended