Filter
Top Products
2 MAN#650336
ROAD GLIDE FLTR
You will need to remove the speedometer and tachometer instrument bezel. To do this, remove two small
screws on the left and right side of the bezel. Then lift up on the back of the bezel and slide the tab that is under the
ignition switch out from under the switch cover, see photos below of ignition switch cover removed to show detail. Now
unplug the gauge connections (cable where applicable). Remove switch, and unplug the idiot lights so the bezel can be
completely removed for easier installation of the new gauges. Remove the clamp(s) that hold the gauges to the bezel
and remove the gauges and grommets/gaskets.
Picture of tab (switch cover removed) Bezel removed Gauges/Grommets removed
Install New Gauges
Next you are ready to install the new gauges into the fairing. The new tachometer comes supplied with a new
gasket and clamp. Install the gauge and secure using the supplied clamp and gasket. Be sure the alignment tab on
the clamp lines up with the notches in the fairing. Some fairings may only have one notch, line up at least one tab on
the clamp with the notch in the fairing, this will insure the gauges are centered and aligned correctly.
Tachometer