Filter
Top Products
DOORS 9P – 15
DAEWOO M-150 BL2
D109C583
5. Disconnect the outside door handle rod from the door
lock.
a. Outside door handle rod.
D109C586
6. Disconnect the door lock from the vehicle.
D Remove the screws (1).
D Remove the door lock (2).
Important: Disconnect the actuator connector if
equipped with the central door lock system.
D109C587
Installation Procedure
Notice: Dissimilar metals in direct contact with each
other may corrode rapidly. Make sure to use the correct
fasteners to prevent premature corrosion.
1. Install the rear door lock with the screws.
Important: Connect the actuator connector if equipped
with the central door lock system.
2. Connect the outside door handle rod to the door lock.
3. Install the guide rail with the screw.
4. Install the seal trim. Refer to “Door Seal Trim” in this
section.
5. Install the door trim panel. Refer to Section 9G, Interi-
or Trim.
6. Connect the negative battery cable if equipped with
the central door lock system.