Filter
Top Products
Diesel Engine Complete Engine
62
Tappet
NOTE: Rotate the engine block so that the cylinder
head side is down.
Coat the tappet with engine oil and install into the
block.
Crankshaft
CAU
TIO
N
Confirm that there is no dirt or dust stuck to the
rear face of the bearing before installation. Debris
behind the bearing can cause severe engine
damage.
NOTE: Coat the inside face of the bearing with
engine oil (SAE 30) before installation.
Align the protrusion of the upper main bearing with
the notch in the cylinder block.
Install the upper main bearings.
CAU
TIO
N
Do not hit the crankshaft against the cylinder
block. Damage to the block or crankshaft can
occur.
Position the crankshaft and gear in the cylinder block.
Main Bearing Cap
CAU
TIO
N
Confirm that there is no dirt or dust stuck to the
rear face of the bearing before installation. Debris
behind the bearing can cause severe engine
damage.
NOTE: Coat the inside face of the bearing with
engine oil (SAE 30) before installation. The
number stamped on the main bearing cap
must be the same as the number stamped
on the cylinder block.
Align the protrusion in the lower main bearing with the
notch in the cap.
Install the lower main bearing into the main bearing
cap.
00900215
00900216
00900204
00900217