Filter
Top Products
Display Panel
15 Display Panel
DRIVE WHEEL DIRECTION INDICATOR
TRAVEL DIRECTION INDICATOR
BATTERY CHARGE DISPLAY
The green bars show how much
charge is left. Have the battery
changed or recharged if the yellow
light is flashing.
PERFORMANCE LEVEL
Access to this setting is determined by your
company.
WRENCH LIGHT
A yellow light means something needs to be fixed.
Report the trouble to your supervisor.
PARKING BRAKE LIGHT
A red light means the parking brake is applied.
STEERING SYSTEM ERROR
Check the message panel.
LOW BRAKE FLUID LEVEL LIGHT
ERROR LIGHT
A yellow light means you have tried to perform an operation
that is not permitted. Check the message display.
SERVICE AND OPTION BUTTONS
Your employer will instruct you on the use of these buttons. A PIN may be required.
MESSAGE PANEL (see page 16)
CAPACITY DATA MONITOR (see page 16)
Display Panel 16
CAPACITY DATA MONITOR (see Caution below)
• Fork height lights:
A yellow fork will light to show
which lift zone the forks are in. If any of these lights
are on, it means the load backrest is higher than the
collapsed height of the mast. Make certain the load and
load backrest will clear any obstructions above you.
The yellow light will flash and alarm will "beep" if you
travel faster than the load positioning speed (2.4 kmph,
1.5 MPH) while the load backrest is above the collapsed
height of the mast.
• Lift height lights:
The green bars will light to show
how high, or to which lift zone you can raise a load.
OVERLOAD WARNING:
If the load is too heavy for the lift
zone the forks are in, the alarm will "beep". Check the
message display.
Caution:
All information displayed by the fork position lights and/or the Capacity Data
Monitor is for reference only. You must always be alert to load center, load distribution,
load height and load weight. You must also be aware when the load or load backrest
extends above the top of the mast, and how much overhead clearance is needed.
FORKS DOWN LIGHT (see Caution below)
The green fork means the mast is at its minimum collapsed
height. Make certain the load and load backrest will also
clear any overhead obstructions.
MESSAGE PANEL
Anytime you hear a “beep”, or if the truck slows down
or won’t work, check here for instructions, or to identify
the problem area.